Description
For users seeking a sleek, refined, anti-rotation QD end plate, the C2E Contour Connect End Plate is the perfect compliment to any AR15 or AR10 pattern rifle. Perfect for single point slings, where rapid strong to weakside transitions and rapid primary to secondary firearm transitions are desired.
Made from heat treated ordnance grade steel, and manganese phosphate finished for extreme durability. with a machined 8 position anti-rotation QD sling mount socket, the C2E follows the contours of the forged Mil-Spec lower perfectly, giving the lower receiver end plate a forged feel. A 45 degree chamfer with smooth corner radii gives the C2E a premium feel your rifle always should have had.
0.5 ounces
- Heat treated ordnance grade steel
- Mil-Spec Manganese Phosphate finish
- 8 position Anti-Rotation QD Socket
- Smooth contour matching geometry for Mil-Spec forged lower receivers
- Minimalist value added firearm enhancement
- weight: 0.5 ounces
Gilberto Barraza –
This end plate is the best end plate you could buy. It fit my lower receiver lime they had made it exactly for my lower. The locating tab is nice and fat. Perfectly square with my buffer tube. Does not slip while tightening up the castle nut. The QD mount is just a bonus in my eyes. I’ll never use a cheap end plate again. Buying for my other builds and to have extras.
Susquehanna Valley Firearms LLC –
Hi quality part. We switched to selling these from the BCM endplates. They were a better cost and the machining is nicer.
Mario –
Let’s be honest, an end plate is an end plate. BUT the attention to detail that Griffin put into this is amazing. Lines up absolutely perfect with standard forged lower. Again, not a huge deal and has nothing to do with functionality but if you’re OCD about some of that stuff like I am, this is the end plate for you!
Chuck H –
I ordered this endplate from primary arms. The design and machining are fantastic. The reason for a 4 star review is that it the example I received was nearly impossible to stake to the castle nut. While it is a very tough endplate, the heat is a little overboard for the application in my opinion.
Harlan –
I purchased this item through another company, however, I wanted to leave a review here. PURCHASE WITH CONFIDENCE!
Tom –
The best I have used by far.