Built well
No noticeable difference in muzzle rise
The Micro Carry Comp was developed to provide concealed carry gun owners with enhanced recoil mitigation and muzzle control without unnecessary weight and bulk. Adding only a few tenths of an inch in length beyond a typical thread protector the patent pending Micro Carry Comp provides brute strength and gas direction with its close dimensioned 17-4SS ported baffle face. Significantly reducing recoil increases split times between shots while decreasing group sizes. Its minimal size and weight ensure that the Micro Carry Comp will not significantly print on concealed carry clothing like other comps or burden the end user with unnecessary weight. Wrench flats provide easy gripping surface to torque the device into place and ensure it stays put even for long training weekends on the flat range. At $64.95 the Micro Carry Comp is a value and an impressive performance add on for your favorite carry piece. The Micro Carry Comp ( MC²) provides low signature, optimal holster compatibility and good muzzle brake performance in a miniature and lightweight package which has near zero perceived effect on the handling and storage of the firearm. Improve your defense today. Stay aware, stay safe and remember only hits count!
*NOTE*
1/2x28: Indexes off the barrel shoulder. For use on standard, sub compact, compact, and full-size tilt-barrel firearms that have a normal profile of barrel (G19, G17, P320, S&W M&P 2.0).
1/2x28 Special: Indexes off the face of the muzzle. For use on micro compact tilt barrel firearms with little to no barrel shoulder due to the thinner profile of the barrel (G43, G43x, G42, G48, P365, P365XL, Hellcat).
If you are concerned about fitment, the 1/2x28 special will work on a normal profile barrel as well. It will operate the same, but if you have a longer threaded surface on your barrel, you may see uncovered threads rearward of the muzzle device when using this option.
No noticeable difference in muzzle rise
Perfect for what it is. I bought this to basically just be a thread protector that might compensate a little, and it’s been awesome. No timing or adjusting needed, just screw on and shoot. No complaints here
easy to install and works well. It would be nice to know if the the device needs to be timed when installing.
Great comp, high quality, easy install. It’s Griffin Armament what more can I say.
Wish there was a better way to torque it down. Very hard to grab onto. Otherwise great product from fellow military personnel.
Fits perfectly. Finish is great, matches my Walther PPQ perfect. Did have to open up bottom of Kydex holster a bit for it. Have not shot it yet, can't wait.
While this is the first time I have used a compensator, I confess to being rather impressed with the improvement in the behavior of the FN509 I shoot. Using the compensator led to better groups - even the brass casings were gathering more closely together than when i took off the compensator for a side by side test. The fact that it hardly adds any length to the barrel makes it all the more reason i am keeping it on there permanently.
There is a noticeable difference when installed on my Glock 43X. There may be better devices but not this small. It is very effective with Sig 365 9mm self defense rounds.
I actually have 3 of these now. As one would expect they dont make a huge difference in felt recoil but its certainly noticeable and if you have a threaded barrel the simplicity and quality cant be beat. Why not just run one of these in place of your thread protector when not using a can.
The fit and finish is amazing and it looks great on my XDM 9mm. The only reason for 4 stars rather than 5 is that I’ve not had time to evaluate it’s performance on the range.